RGBLink Mini+ and PTZOptics PTZ Camera Tutorial

Paul Richards of PTZOptics reviews the RGBlink mini+ and goes over how it works with PTZ control. The RGBlink mini+ streaming switcher allows you to switch seamlessly between any of the four HDMI inputs and output to both HDMI and the dedicated USB 3.0 output. PTZOptics has a wide range of PTZ cameras that all work great with the mini+. Check out Paul's review and tutorial below. 



"PTZOptics is excited to announce PTZ camera control integration with the new RGBLink Mini+ video switcher. The RGBLink Mini is a 4-input HDMI video switcher with some really nice features including a programmable USB output, HDMI output and on-board 2” preview screen. The device features 4 simple buttons for video switching along with a T-Bar and much more.

Here are the step to enable your RGBLink to control PTZOptics cameras.

1. Plug your RGBLink Mini into your local area network with an ethernet cable.

2. Set the IP address of your RGBLink Mini to an IP address on your local area network.

3. Plug your PTZOptics camera into the local area network and make sure it has a static IP address on the LAN.

4. Using the "S" button navigate to the PTZ camera control area of the RGB Link Mini. Here you can setup your switcher to control PTZOptics cameras by entering the static IP address of your camera and enabling PTZ controls."
Paul Richards

Check out the tutorial and review on YouTube here!

Check out the article here!

Learn more about RGBlink here!

Learn more about PTZOptics here!



Leave a comment

Please note, comments must be approved before they are published

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.